7.
Remove screw (3).
8.
Take off hold-down clamp (2).
Note:
Support ring on injector must likewise be
removed if it does not come out with the
injector.
9.
Use the puller to pull out injector (1).
10.
After removal, seal all openings with suita-
ble covers.
Installing injector
1.
Remove all covers before installation.
2.
Clean sealing surface on cylinder head and
protective sleeve.
Note:
Use a new sealing ring whenever the injec-
tor is installed.
3.
Coat sealing ring on injector (1) with as-
sembly compound.
Note:
Use either the press-fitting tool or the hold-
down clamp (2) to press injector (1) into
the cylinder head.
4.
Align faces on injector (1) for mounting in
the hold-down clamp (2) and insert injector
by hand in a straight line into the cylinder
head.
5.
Fit hold-down clamp (2) in correct position
by hand.
Installation without press-fitting tool
1.
Screw in screw (3) and tighten screw (3) to carefully push injector (1) into cylinder head.
Name
Size
Type
Lubricant
Value/Standard
Screw
M8
Preload torque
(Engine oil)
5 Nm
2.
Release screw (3) again and relieve hold-down clamp (2).
Installation with press-fitting tool
1.
Place press-fitting tool on hold-down clamp (2) to press injector (1) carefully into the cylinder head.
2.
Place hold-down clamp (2) in correct position, screw in screw (3) and tighten snug-fit.
102 | Task Description | MS150118/01E 2015-05
TIM-ID: 0000050909 - 004