Centrifugal oil filter – Cleaning
and filter-sleeve replacement
1.
Slacken off nuts (4) crosswise.
2.
Remove housing cover (1).
3.
Carefully remove rotor (3) from lower part
of housing (5).
4.
Remove nut (2).
5.
Carefully remove rotor cap.
6.
Remove filter sleeve from rotor cap.
7.
Measure thickness of oil residues on filter
sleeve.
Result:
If the oil residues exceed the maximum lay-
er thickness of 25 mm, shorten the mainte-
nance interval.
8.
Disassemble rotor tube, filter cone and ro-
tor bottom.
9.
Wash out rotor cover, rotor tube, filter cone
and rotor bottom with cold cleaner.
10.
Blow out with compressed air.
11.
Check sealing ring, fit new one if necessa-
ry.
12.
Insert new filter sleeve into rotor cap with
the smooth paper surface facing the outer
wall.
13.
Assemble rotor tube, filter cone and rotor
bottom with sealing ring.
14.
Carefully insert rotor in lower part of hous-
ing.
15.
Use torque wrench to tighten nut (2) to specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Nut
Tightening torque
8 Nm + 1 Nm
16.
Fit housing cover (1).
17.
Screw on nuts (4).
18.
Use torque wrench to tighten nuts (4) crosswise to specified tightening torque.
Name
Size
Type
Lubricant
Value/Standard
Nut
Tightening torque
12 Nm + 2 Nm
MS150118/01E 2015-05
| Task Description | 125
TIM-ID: 0000051622 - 005
