10.
Pull the weather strip rubber gasket up at the passenger side rear door, pull up all the way to the roof of the vehicle. If
you are standing at the rear passenger side door, look into the vehicle on the left hand side on the bottom of the rear
panel, there is a metal clip. This was hidden underneath the rubber gasket you removed earlier. Pull the metal clip up.
It is holding the front of the panel into place. Next pull from the top of the panel. You will find a tab on the bottom of the
panel, towards the front under the carpet. Remove the phillips head screw. Pull up and out on the panel to free it. The
panel will still be attached by the seat belts at the front and the rear, but you will be able to get enough slack to pull it to
the opposite side of the vehicle. This will give you enough room to work.
11.
If vehicle was equipped with factory amplified subwoofer system remove three 11/32” bolts holding it into place.
12.
Place gasket provided around woofer hole cutout. Connect black wire to negative side of woofer and red wire to the
positive side of woofer. Using screws provided install woofer into enclosure, making sure not to overtighten screws to
avoid stripping.
13.
To install grill into factory panel, the cargo tray must be removed. Unsnap the 9 white clips around the perimeter of the
trim ring back. The trim ring along with entire cargo tray assembly will come out the front. Retain the clips and tray, you
may want to replace it if you sell the vehicle.
14.
Install grill furnished into the front of the panel into the location previously occupied by the trim ring. Using the 1/2” screws
provided, screw grill from back through the factory slots in the panel
15.
Place enclosure into empty location behind the area that was occupied by the cargo tray. Using screws and washers
provided mount the enclosure to vehicle through 3 holes in enclosure.
16.
Make speaker connections to the enclosure from the amplifier, loosen terminal knobs (a 13mm nut driver can be used).
Connect speaker wires from amplifier to enclosure, positive to red terminal knob and negative to black terminal knob.
17.
Replace the factory side panel. This is fairly easy, just reverse the process of removal. The rubber trim around the door
goes over the top of the panel. It is easier to start at the top and work your way down. Reverse Steps 1 thru 9 to reas-
semble the interior of the vehicle.
FACTORY SPEAKER WIRE COLORS
The drivers side rear speaker wires are located under threshold. 1997-1998 colors are left side, light blue/black (positive),
yellow (negative). 1999-Newer tan/white (positive), tan/yellow (negative).
The passengers side rear speakers are located under the threshold. 1997-1998 colors are right side, purple/white (positive),
light blue (negative). 1999-Newer tan/green (positive), brown/pink (negative).
Although every effort has been made to assure proper wiring color, Mitek is not responsible for any changes made by the
vehicle manufacturer which sometime occur. If wiring colors do not match then physical verification is required. These in-
structions are guidelines only and in no way are intended to replace a professional installation. As always before screwing
and drilling check to make sure you will not damage wires, hoses or cause damage to the vehicle.
MAXIMUM ENCLOSURE MOUNTING SPECIFICATIONS
2 1/2"
10 3/8"
8"
9 3/16"
5 1/8"
One Mitek Plaza Winslow, IL 61089 BassSlammer.com 1-800-225-5689
21A7896
