MTX CM120 User Manual Download

Page: 31 / 92

CONCRETE MIXER

• Use goggles, protective gloves, solid nonskid footwear and, if necessary, a helmet. When working

in a dusty environment, use a respirator.

In the course of tests the noise level is determined by the standard methods. However, when using
the concrete mixer, especially indoors, the size of the room can cause the increase of the noise level
above 85 dB, due to the acoustic properties of walls, fl oor and ceiling).
If the noise level during the work exceeds the stated value, use special earphones.
. Use of the concrete mixer is prohibited in condition of strong fatigue, under alcoholic, drug
intoxication or under the infl uence of potent medical drugs, as well as to the minors and the
persons who have not read and understood the operation manual.
•  Use the concrete mixer only for the works listed in the section "INTENDED USE".
•  Make sure that all protecting devices are installed and serviceable.
•  Do not use the concrete mixer without protective devices or if they are damaged.
•  Do not use the concrete mixer with the faulty switch. The concrete mixer with the faulty switch

constitutes danger and demands repair. Before use of the concrete mixer repair or replace the
switches.

• It is forbidden to change the machine design or its separate parts.
• Immediately replace the faulty or damaged machinery parts by the original ones recommended

by the manufacturer of the concrete mixer.

•  Do not touch the mixing drum during the concrete mixer operation.
•  Perform loading and unloading of the mix only when the concrete mixer is active.
•  Observe the direction of rotation of the mixing drum: in the direction of an arrow on the mixing

drum or counterclockwise from a loading port.

• Before manually moving the concrete mixer at the site empty the drum.
• It is obligatory to disconnect the mains plug of the concrete mixer from mains socket in the

following cases: movement and transportation, performance of works for cleaning, maintenance
and servicing, stop of the concrete mixer (even at short-term breaks in work).

• It is necessary to watch operability of a conducting cord, do not allow its twisting as well as the

laying of the cord through access roads and in places of warehousing of materials.

• Repair, service, preservation and dismantling are performed only with the completely switched

off electric equipment.

• All works for connection and repair of electric equipment should be made only by the electrician

of not less than 2nd category (with access to installations up to 1000 V).

• When preparing lime mortars work in goggles and have at hand clean water for washing the eyes

in case of possible contact of the mix or its components with eyes.

• It is forbidden to use any devices for the accelerated unloading of the mix from the concrete

mixer.

• Work with the uncovered electric drive is strictly forbidden. It is forbidden to leave open the

electric drive in order to prevent moisture and foreign objects from entering.

• Work with the mixer is forbidden, if the switch, plug, cord are faulty, and also, if the motor

malfunctions (smell of burned insulation), if there is an increased noise, hammering, vibration.

•  Before starting the mixer give a preventive audio signal.
•  The mixer is provided with the protection against electric shock of class II.
•  Use the corresponding overalls for work. Loose clothes, jewelry can be caught in by moving

parts. Use the corresponding overalls

• and solid footwear. Do not put on hanging jewelry in order to avoid drawing in the rotating parts

of the concrete mixer. Protect legs and feet from the scattering residues the scattering garbage.