M T X . C O M
3
GENERAL OPERATION
1. Power / Standby - Power on or switch to standby mode.
2. Speed Down - Press to decrease speed of flash.
3. Speed Up - Press to increase speed of flash.
4. Static Color - Cycle through static colors.
5. Static Color - Cycle through static colors.
6. Adjust Dynamic Mode - Cycle through dynamic modes.
7. Adjust Dynamic Mode - Cycle through dynamic modes.
8. Brightness Up - Press to increase brightness.
9. Brightness Down - Press to decrease brightness.
10. Demo Mode - Loop through nine dynamic modes. Each mode will play three times.
INSTALLATION
Do not install the dongle/RF receiver in enclosed metal parts, as this may interfere with connectivity
between it and the remote. Remote Battery: 3V CR2025 (use only the approved battery)
Connect the MUDLEDC LED pig-tail (left) to the MUDLEDC LED dongle (right). The dongle is keyed
and will only fit when oriented properly. To prevent battery discharge, install a switch on the RED
MUDLEDC power wire so you can turn off the MUDLEDC’s remote receiver when the vehicle is
stored.
• You can use the remote turn-on lead from the head unit to trigger a relay. However, do not
connect the MUDLEDC power wire directly to the head unit power wire; it pulls more current than
a typical turn-on circuit provides.
• You can also use the stereo’s rocker-style power switch on the dash, if equipped, to turn the
MUDLEDC controller On and Off.
• You can also simply install a toggle or rocker-switch in a convenient location.
Do not wire your MUDLEDC’s power wire into your navigational lighting circuit. Depending on USCG
or local laws, it may be inappropriate or illegal to be showing navigation lights and accent lighting.
Connect all LED capable speakers and MUDLEDC LED pig-tail wires together according to color. Each
LED pig-tail will have Green, Red, Blue, and Black wires. Splice every green wire together, every red
wire together et al. Test for functionality with the remote. Troubleshoot beginning with power and LED
wiring. If problems persist, test with one speaker to ensure the MUDLEDC is functioning properly.
