door thresholds need to be removed.
4.
Remove passenger side kick panel. Pull firmly from the bottom this
will unsnap easily.
5.
Route 10ga red power wire from furnished wiring harness starting at
pre amp location. Route wire under rear seat on passenger side, over to
threshold and under carpet to the front of vehicle.
6.
Open hood.
7.
Locate the factory grommet on the fire wall on the passenger side just
to the inside of the battery. It will be a black grommet about two inches
in diameter. This pulls out very easily. Cut a small "X" in the center of the
grommet to accept 10ga power wire.
Grommet
Battery
8.
Route 10ga red power wire through grommet into the engine com-
partment.
bass. Turn the source unit to maximum listening level. You should know
that some source units will produce distortion or “clip” before the unit
reaches maximum volume. Reduce volume to the loudest listening level
before distortion. Turn the gain knob on the Thunderform pre amp clock-
wise until the speaker starts to distort and reduce gain to loudest listening
level before distortion.
Optional
- The EBC, or Electronic Bass Control, allows a remote bass
control to be adjusted from the driver's seat.
Setting Crossover
You should set the crossover to your own personal listening taste. The
crossover is adjustable to any frequency between 50Hz (counterclock-
wise) to 150Hz (clockwise). As a guideline, the goal is to create the illu-
sion of bass up front. The higher the crossover point the more “audibly
visible” your sub is going to be. Take your time and really listen to your
system, grab a soda and a few of your favorite tunes and have fun.
TROUBLESHOOTING TIPS IF AMP DOES NOT TURN ON
Check all connections at battery and that fuse is installed
Check speaker wire connections
Check ground
Check fuse on pre-amp
19.
Reinstall threshold trim. Locate and align holes in vehicle with pins
on trim; it will snap into place.
20
. Using screws provided, install the enclosure into vehicle as shown
below.
2
5
