BULLDOG 65 Hydraulic Steelworker
6
3.7
3.7
3.7
3.7
S
S
S
S
AFETY
AFETY
AFETY
AFETY
P
P
P
P
OINTS
OINTS
OINTS
OINTS
•
All adjustments, setting, change of tooling and maintenance must be carried out by a
suitable qualified engineer in accordance with the manufacturers instructions.
•
Remove off-cuts, slugs and any other waste from around the machine before leaving the
work station.
•
The operator should check all tooling is in good condition before operating machine.
•
All stations should be checked for obstructions.
•
Heavy work should be supported by a sound work steady.
•
The machine should never be left running while unattended.
•
When leaving, the machine MUST be switched off.
3.8
3.8
3.8
3.8
O
O
O
O
VERLOADING
VERLOADING
VERLOADING
VERLOADING
In the event of an accidental overload to the hydraulic circuit, the oil will be diverted direct
back to the tank via a relief valve, until the overload condition is removed.
IT MUST BE STRESSED HOWEVER IT IS NOT ADVISABLE TO EXCEED THE
CAPACITY OF THE MACHINE USING RELIEF VALVE AS A SAFETY VALVE.
3.9
3.9
3.9
3.9
W
W
W
W
ARNINGS AND
ARNINGS AND
ARNINGS AND
ARNINGS AND
D
D
D
D
ANGERS
ANGERS
ANGERS
ANGERS
Any point of the machine painted RED should be treated as a danger area. Operators should
be instructed not to extend any finger or limbs into or beyond the vicinity of the warning
labels. Any guards or hold downs removed for maintenance or adjustments MUST be replaced
before the machine is put back in service.
