12
Instrument Panel
1. Neutral Light:
Illuminates when both control levers are in neutral position. This is required for the vehicle to start.
2. Low Hydraulic Oil-L Warning Light:
Illuminates when the hydraulic oil is dangerously low on the driver side tank. If illuminated, stop vehicle
immediately and diagnose why the oil level is low, repair, then fill.
Note:
Not applicable on early models.
3. Low Hydraulic Oil-R Warning Light:
Same as #2 but for passenger side oil tank.
4. Parking Brake Light
: Illuminates when the parking brake is engaged. This is required for the vehicle to start.
5. Digital Display:
This electronic monitoring system shows engine RPM, oil pressure, coolant temperature and battery voltage. Located below the
screen are buttons used to cycle through various digital displays. Refer to engine manual for additional information.
6. Fuel Gauge:
The fuel gauge monitors the amount of fuel left in the vehicle. When traveling to remote locations, the vehicle should always be
filled with additional fuel cans in case of emergency. Leave enough fuel to return back to your starting location.
7. Range Switch:
This switch controls the High and Low range of the Mudd-Ox. High range is only to be used for travel. Any work or pulling of
trailers must be done in low range.
Always
come to a complete stop with the control levers in neutral position before changing range.
8. Head Lights Switch:
Flipping the switch to “ON” will activate the headlights and tail lights.
Never
operate the Mudd-Ox at night without lights.
9. Emergency Bypass Switch:
It is designed to override preliminary startup procedures to quickly start the vehicle. By holding the switch in the
“ON” position, it will bypass the need for control levers to be in neutral, and will bypass the parking brake.
Note:
this is for emergency use only.
Using this switch without care could cause the vehicle start and immediately move depending on operator lever location.
10. Bilge Pump Switch:
When in an emergency, if the Mudd-Ox has water in the lower body, quickly flip on the bilge pump switch. This will im-
mediately begin to pump water out of the vehicle.
Caution:
This is a feature to remove small amounts of water. If the machine is completely
filled, you must quickly exit quickly.
Summary of Contents for FORT MAC 85 HP
