Muddy the Liberty MTP3000, Instruction Manual

ATTENTION!! 

WHEN YOU SEE A “  WARNING!” BE SURE TO HEED THE MESSAGE! 

THE INFORMATION CONTAINED IN THESE MESSAGES CAN SAVE YOUR LIFE!!

READ THIS MANUAL IN ITS ENTIRETY PRIOR TO USING THIS PRODUCT.

This instruction manual complies with the ASTM standard F2123 - Standard Practice for Treestand Instructions.

10

STEP 11. 

Lay the assembled top section down with the 

front up (“the front” is the side where the ladder sections 

will be attached—see Fig. 6/pg. 8). Attach the 

top legs 

to 

the 

standing platform 

using (4) 5/16’’ x 3 1/4’’ hex bolts 

[H], (8) nylon washers and (4) 5/16’’ nylock nuts. Then 

connect the

 middle legs 

to the 

top legs 

and the 

bottom 

legs 

to the 

middle legs 

using (4) 5/16’’ x 2 1/4’’ hex

bolts 

[F], (8) nylon washers and (4) 5/16’’ nylock nuts to secure. 

Insert the 

adjuster legs 

into the 

bottom legs 

and

secure 

at desired height using (2) snap pins (Fig. 5). 

NOTE:

 Make 

certain the snap pins are engaged and the “wire keeper” is 

secured, see snap pin illustration below.

Top Leg

Top Leg

Standing

Platform

H

H

H

F

F

Middle Leg

Middle Leg

Bottom Leg

Bottom Leg

F

Adjuster Leg

Adjuster Leg

Snap Pin

Snap Pin

F

H

FIG. 7

SNAP PIN ILLUSTRATION

Wrap snap pin closure around 

front of tubing and secure 

over end of pin.