T H E W O R L D P O W E R I N A N C H O R I N G S Y S T E M S
MAINTENANCE AND ASSEMBLY INSTRUCTIONS – VR600 and VRC600
•
The Motor/geardrive assembly should be protected with anti-corrosion film or grease tape.
•
Check for any corrosion or paint chips and treat.
•
Check motor terminals and clean.
Standard VRC600
For this you require the clutch handle, 3mm and 6mm
allen keys and a marine grade grease.
1. Remove two screws and chain cover.
2. Remove peeler.
3. Fully unscrew clutch nut and remove capstan.
Remove key from shaft. Hold the peeler arm out and
remove gypsy.
4. Repeat steps 1-3 in reverse order. Lubricate shaft,
gypsy, drive cone and capstan.
Standard VR600
For this you require the clutch handle, 3mm and 6mm
allen keys and a marine grade grease.
1. Remove two screws and chain cover.
2. Remove peeler.
3. Fully unscrew clutch nut and remove D washer. Hold
the peeler arm out and remove gypsy.
4. Repeat steps 1-3 in reverse order. Lubricate shaft,
gypsy and drive cone.
VR600 With Locking Pawl
For this you require the clutch handle, 3mm and 6mm
allen keys, a small screwdriver and a marine grade
grease.
1. Remove screw on side of chain cover. Carefully
remove locking pawl, spring and ball bearing.
(Spring and ball bearing may be stuck to the bottom
of the locking pawl).
2. Remove two screws and chain cover.
3. Remove peeler.
4. Fully unscrew clutch nut and remove D washer. Hold
the peeler arm out and remove gypsy.
5. Repeat steps 1-4 in reverse order. Lubricate shaft,
gypsy and drive cone.
VR/VRC/VFF 600 12/01/2015
muir.com.au
10
