HOW TO USE
HOW TO KEEP
EMERGENCY
1. Avoid to install the place marked.
2. Connect the power plug with power outlet.
3. Fill warm water 1,500ml(SD-200H) / 3,000ml(SD-250H) in the tub.
- Add a ultrasonic cleaning liquid(16plus, 11un) for better performance.
(Note : It may cause the shape changes for some items like glasses or plastic during heat-mode.)
4. Add the items into the tub.
5. Turn on the Timer for operation.
6. Take out and rinse the remained liquid from the surface of items by using towel.
7. Cover up the cover of tub after operations. (Note : It may cause the shape
changes for some items like glasses or plastic during heat-mode.
1. Eliminate the liquid after the plug off the power.
2. Wash the tub and keep well in dry condition.
(Note : It may cause the shape changes for some items like glasses
or plastic during heat-mode.)
Problems
Solutions
No Ultrasonic Operations
No operations / Lamp for
operation is normal working
The circuit board may have damaged
and call A/S center for repairs.
Increasing Liquid Temperature
during operations
Do not operate the device for hours.
(The liquid temperature may go up to 70~80C
when you use over 30min without break time.)
Check the power plug in.
Check the fuse box.
Call A/S center for repair.
