tint-BULB + MOBILE SWITCH
INSTRUCTION MANUAL
29
Basic functions
Switching on/off
Press the standby button to switch the bulbs on and off again. The memory function
will store the last “illumination state” and will start again automatically the next time
the bulb is switched on.
Set brightness
Long-press to set the desired brightness on a continuous scale.
Favorite button
Please set the preferred brightness.
Push and holt the Favorite button for roughly 5 seconds
You have set the selected brightness value and can quickly access the value by briefly
pressing the Favorite button.
Adding a new bulb
Take note of the technical specifications when purchasing new bulbs. We recommend tint
bulbs from Müller-Licht. When using bulbs made by other manufacturers, it is not guaran-
teed that all features will be supported or will work as intended.
1. Unplug the lamp at the mains, remove the old bulb and screw the new tint bulb into the socket.
2. Plug the lamp back in at the mains and set the corresponding light switch to I or ON.
The new bulb will signal that it is in coupling mode by briefly increasing and decreasing
its brightness and changing colour if applicable. If this does not occur, switch the bulb
off and on again 5 times.
3. Hold the remote control very close (
<
10 cm) to the new bulb.
Press the standby button and the brightness button (large sun) of the remote control.
The new bulb will signal that it has been connected to the remote control by briefly
increasing and decreasing its brightness.
The procedure will then end and you can use the remote control as normal.
