tint-STARTER SET
INSTRUCTION MANUAL
45
Remove a bulb from the tint remote control
1. Switch the bulb off (i.e. to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button.
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The bulb will signal
that it has been selected by increasing and decreasing its brightness.
5. Hold down the standby button for approx. 5 seconds.
The bulb will then signal that it has been removed from the tint remote control and
the procedure is finished by flashing and then dimming.
Add a bulb from one group into another group
1. Switch the bulb off (i.e. to standby) with the tint remote control if necessary.
2. Select the group you would like to change using the group button. (If you would like to
add a bulb from group 2 to group 1, for example, press the group button repeatedly until
the middle LED above the group button lights up).
3. Hold down the group button for approx. 5 seconds.
The feedback display will blink red/green.
4. Select the desired bulb by pressing the group button repeatedly. The bulb will signal that
it has been selected by increasing and decreasing its brightness. The bulb will blink in
the order in which they are stored in the tint remote control.
5. Hold down the group button again for approx. 5 seconds to store the selected bulb in
another group.
The group display for group 1 will light up.
6. Using the group button, select (if necessary) the group to which you would like to add
the bulb.
After approx. 10 seconds, the bulb will be added to the selected group and the
feedback display will stop blinking. Wait this long, not pressing any buttons during this
time.
The procedure will then end and you can use the extended group as normal.