tint-STARTER SET
46
INSTRUCTION MANUAL
Resetting the tint remote control
A reset will only be required in exceptional cases, such as when the bulb no longer res-
ponds to the tint remote control after removing and reinserting the batteries.
Resetting the remote control will delete all pre-defined group settings and you will have to
connect the tint remote control and the bulbs again afterwards.
1. Remove the battery compartment cover.
2. Use a pointed object or the battery compartment cover to press the reset button on the
back of the remote control.
3. Then, proceed as described in the section “Resetting the tint bulb” and then as
described in the section “Adding a new bulb”. Each bulb will then have to be connected
individually one after the other. If, for example, three bulbs belong to one group, you
must repeat the steps in “Adding a new bulb” 3 times.
Resetting the tint bulb
Resetting the tint bulb is only required in exceptional cases, such as when the remote
control has had to be reset.
1. Switch the tint bulb on and off 5 times
2. Switch the tint bulb on again. It will now begin to cycle through its colours. The reset has
occurred as desired and you can now use the tint bulb as normal using your remote
control or other Zigbee system.
Resetting the light colour
Resetting the light colour may be necessary if you have previously assigned the lights to
another function, such as the ‘Night light’ scene. The corresponding control unit is inacces-
sible or the batteries might even be dead. You can set the light colour to warm white very
easily without completely resetting the bulb. This function can even be used regularly if the
tint remote control is not in arm’s reach at that moment.
1. Use the light switch to switch the bulb off and on again 3 times.
2. The bulb will now start in its basic setting, warm white, 100%
