tint-STARTER SET
INSTRUCTION MANUAL
47
Problem
Possible causes
Bulb is not working.
The batteries in the tint remote control are
dead and must be replaced.
The bulb itself is switched off or the mains
plug is not plugged in.
You have selected the wrong group, or
have not selected a group, using the group
button. Select the right group or select “All
groups” by pressing the group button re-
peatedly (all LEDs above the group button
will light up).
The wrong bulb lights up.
Use the group button to select the right
group or use the group button to select
“All groups”.
The light switches off suddenly.
You have selected the “Sunset” scene. Not
an error.
You have added a new bulb and this bulb
switches off when you select a coloured
light function.
The new bulb can only light up in white.
Not an error.
You want to add a new bulb, but the ones
that are already added are blinking.
Switch off the bulbs that are already added
or remove them from the product that has
already been connected.
The bulb has been added to the wrong
group.
Find out for sure which group the bulb is
in. Proceed as described in “Add a bulb
from one group into another group”.
I cannot add a bulb to a new system.
Please check whether the bulb is in
coupling mode.
Troubleshooting