11
10
On a flat surface, bring vac up
alongside the M5. Place PVC cut
sticker on pipe so that center
marks ALIGN on tee and PVC
stickers.
Back out bolt from M5 hitch
using included hex wrench, and
remove PVC pipe from M5.
5. Mark your cut
6. Remove Bolt
And now the fun part
Align
Lay PVC pipe out
horizontally and make
straight cuts on dash
lines of PVC cut sticker.
Clean any shavings
from pipe.
Remove any sticker left
on pipe after cutting.
Insert top section of pipe along with tee. Twist and push until pipe
is fully seated into coupling and tee. Next, insert support pipe
section (with pre-drilled hole) up through hitch on M5 and connect
to bottom of tee by twisting/pushing together until fully seated.
7. cut PVC pipe
8. Assemble pvc pipe
Waste
Remove sticker
edges after cutting
Cut on dash lines
Thru hole
