7
Function test
CHECK THE SENSORS BY USING THE DISPLAY
To enter the service menu press down button A followed by button B. Keep both
pressed down for about 5 sec. The menu will change and you have entered the service
menu, release the buttons. Here is several options but the most important to check is
"Sensor B" and "Output C".
Use button A to step forward in the menu. Under Sensor B you will see several letters,
big letter is activated and small letter is unactivated.
From left to right in second row:
M/m: Sensor, indicates mixer-motor running time
S/s:
Sensor for the mixer-motor to start. Is activated after each visit.
C/c: Sensor for compost level , indicates when the level of the compost is reaching
the leveling arm.
L:
Sensor for liquid level (always acticated) the number 0 to 4 indicates the amount
of liquid in the tray according to the float.
0 = empty tray, 4 = full (and "liquid high" will show)
The liquid indicator and float adapts to the amount of liquid in the tray. Check the
level in the right hand side tube and if there is about
1
-2 cm (1/2") in the tube, the
sensor should indicate this, with number
1
-2 behind the "L". When the tray is
empty the level should be at 0.
If there is any problem with the indicator or sensor there is a protection mode in the
software where the sensor will stay at L3 and heaters stays on even if there is no
liquid in the tray.
Output C
M/m: Mixer motor, when the motor gets signal and power connects the letter change
from small to bigoch the mixer should start to work.
F/f:
Fanmotor, is activated by number of visits and liquid level.
B/b:
Bottom-heater, is activated by liquidlevel or manual setting. If the liquid is L0
the heater should not be activated .
A/a:
Main-heater (top),works in the same way as bottom-heater.
A
B
A
BROKEN MIXER-MOTOR
Any other mechanical problems will be shown as "defect motor"(see page
11
),
contact dealer.
Note! After the problem has been detected and fixed. Confirm by pressing button B.
For instance "Replace Pin", the information will be turned off.
Otherwise the toilet will continue to remind. After the confirmion, choose "normal"
or "manual" setting as before.
B
EN
