2) Controlling Power To Equipment That Does Not Require A Phone Line
The
Power Stone is not a one-dimensional product. It can control power to virtually any
equipment that requires up to 15
Amps at 120 Volts. You can use The Power Stone to
control power to a lamp, stereo equipment, a crock pot..... any device you can think of that
meets the load specifications of The Power Stone.
a)
The Power Stone is plugged into a 120 Volt wall outlet.
b)
The Power Stone is connected to the telephone line via the supplied line cord. On end is
plugged into the telephone wall jack and the other end is plugged into the port labeled
“LINE”.
c)
The device you wish to control power to is connected to the 120 Volt receptacle on the face
of The Power Stone.
d)
The equipment (lamp, stereo equipment, etc.,) does not require connection co the phone
line.
120 VAC
WALL
OUTLET
LINE
Heplful Tips:
HOME LAMP,
STEREO EQUIP.,
ETC.
- In this installation, the”Power On Call” Automatic Operating mode will not perform as
touted. Since there is no auto-answer equipment (fax or modem devices) in this application,
“Power On Call”, as an operating mode, should be avoided.
- Al1 other operating modes are applicable and will function in this installation, such as
“Reboot”, “Toggle”, “Passive On” or “Passive Off’ and you can also access Manual Operating
mode from a remote location. Remember that to access Manual Operating mode, a telephony
device (answering machine/phone) will need to go off-hook before you can transmit your
security code over the phone line from a remote location. If you do not have a device that will
go off-hook automatically, you can A) reprogram The Power Stone’s Audio/Answer feature to
answer at 3 rings, or B) simply ring The Power Stone 15 times (factory preset).
21
