Multi-Tech CommPlete CC9648, User Manual

2   Installation

CommPlete Communications Server

9

Connections

The rear of the CommPlete Communications Server provides connections to power, communications
lines, and configuration hardware, as shown in Figure 2. Only the power connectors are part of the CC9648
chassis. The other connectors are mounted on removable cards or modules, and are documented in their
respective user guides.

Figure 2. CommPlete Communications Server connectors.

WARNING:

 Wiring from both DC power terminal blocks must be disconnected to remove all power from

the chassis. The power supplies are connected in parallel, so that both power supplies supply power to all
power busses in the chassis. To remove all power from the left power supply, disconnect wiring on the left
terminal block; to remove all power from the right power supply, disconnect wiring on the right terminal
block.

KEYBOARD

VIDEO

CONFIG POR

T

ALARM

T1

IN   OUT

MONIT

OR

KEYBOARD

VIDEO

CONFIG POR

T

ALARM

T1

IN   OUT

MONIT

OR

KEYBOARD

VIDEO

CONFIG POR

T

ALARM

T1

IN   OUT

MONIT

OR

KEYBOARD

VIDEO

CONFIG POR

T

ALARM

T1

IN   OUT

MONIT

OR

-48V 0V

-48V 0V

10BaseT Ethernet connector to
external concentrator (SELV)

10Base-T Ethernet connector to server NIC (SELV)

DB-9P RS-232C connector for configuring
controller (SELV)

DC power (2×)

5 V test point (SELV)

5 V adjust (2×)

RJ-48 T1 connector
(TNV) (4×)

T1 monitor connectors
(TNV) (4×)

RJ-11 T1 alarm connector
(SELV) (4×)

DB-9P COM1 connector
(SELV) (4×)

DB-15S video connector
(SELV) (4×)
Keyboard connector
(SELV) (4×)

0 V test point (SELV)