MultiMobile Owner’s Manual
38
The Modem Does Not Execute the Command Line
C:
Make sure you are typing
‘AT’ at the beginning
of command line (and hit Enter at the end).
C:
Make sure the modem is not in Data Mode.
Type
+++ if necessary.
C:
Make sure your software is set to the same
COMx port as your MT3410ZLX.
The Modem Does Not Give a Response After an
AT Command Was Executed
C:
The echo and/or responses may be turned off
by the
ATE0Q1 commands. Enable the AT&V1
to check Result Codes.
S:
Use
ATE1Q0 then Enter to change them back.
C:
Make sure the modem is in Command Mode
and not Data Mode when you type the AT
command.
The Modem Gives an ‘ERROR’ Response After
an AT Command was Executed
C:
Make sure you did not type an invalid
command.
C:
Make sure your command line is 40 characters
or less.
The Modem Goes Off-Hook and Disables the
Telephone Line.
C:
The modem may be set to auto-answer the
phone when it rings.
S:
Disable auto-answer by typing
ATS0=0 then
Enter at the command line.
