MultiMobile Owner’s Manual
40
No Text Appears on the Screen in Data Mode
C:
The remote modem is not echoing your typed
characters.
S:
Type
ATE0 then press Enter at the command
line. Then turn the software echo feature on.
C:
Your software may not be set to use Full Duplex
or the remote modem may not be set to use Full
Duplex either.
C:
The remote modem may be waiting for you to
type a command before it will reply with text.
No Text Appears on the Screen When in
Command Mode
S:
If you can’t see the characters you are typing,
then type
ATE1 then press Enter.
The Modem Does Not Dial a Phone Number After
Execution of AT Dial Command
C:
If you are using touch tone dialing on a phone
line that requires pulse dialing, then it may not
work.
S:
Use
ATDT in place of ATDP.
Communications Software Dials, but Fails
C:
Make sure the software dialing prefix is
ATDT.
C:
Make sure the software and modem are set to
the same COMx port.
C:
The modem may not have hung up the phone
line since the last call.
S:
Change to Command mode and type
ATH then
press Enter.
