Analog Channels
Eight Analog IN channels are available via 20 pin connector. Please read chapter "Pin Layout" (Analog IN
Connector) in the Appendix for more information. The additional analog inputs are intended for recording
additional information from external devices, for example data from a microphone Two of the eight
analog channels (analog channel 1 and 2) are directly accessible via two Lemo connectors. Signals on
the analog channels are amplified with a gain factor of 2.
Two USB Connectors
Both USB connectors are used to transfer the amplified and digitized data from all data channels and the
additional digital and analog channels to any connected data acquisition computer via USB high speed 2.0
(type A - mini B) cable. Data from one receiver (1) is transmitted via USB connector 1, and the data from
the second receiver (2) via USB connector 2. While using only one receiver, it is not necessary to connect
the second USB.
Important:
It is recommended to connect the USB cables to different USB ports of the computer.
Do not use an USB hub!
Audio OUT
To the Audio Out (3.5 mm phone jack) you can connect an audio system to make the electrical activity
audible. This audio output is real-time. Headphones or a speaker can be connected directly to the AUDIO
OUT. Only two channels at a time can be converted into sound (Stereo).
Side Panel
Sockets for connecting up to two receivers via eSATAp cable.
Please use the connector labelled HS/RE 1 when working with one receiver only.
Summary of Contents for Wireless2100-System
Page 1: ...Wireless2100 System Manual ...
Page 33: ...Datasheets ...