Wireless2100 Hardware Setup
Place the receiver within transmission range of your experimental setup. To get optimal results,
keep the distance as short as possible.
Place the interface board not further then 2 m away from the receiver, and connect the two with
the eSATAp cable.
Connect the power supply to the interface board.
Connect the interface board with a USB2.0 port of a computer where MC_Rack is already installed.
Avoid USB 3.0 ports (USB 3.0 ports are blue). Do not use USB hubs.
Switch on the Wireless2100-System on the interface board. LEDs on the interface board and receiver
should light up.
Connect a charged battery to a headstage.
MC_Rack Setup
Start MC_Rack. To define the Wireless2100-System as data source, please open the
"Data Source
Setup"
in the
"Edit"
menu.
Summary of Contents for Wireless2100-System
Page 1: ...Wireless2100 System Manual ...
Page 33: ...Datasheets ...