User Manual
12
3.
Making Measurements
Measuring AC or DC Voltage
Warning: Do not measure any voltage of over 1000 Vdc or 750 Vac rms to
avoid instrument damage or electric shock.
Do not apply more than 1000 Vdc or 750 Vac rms between the
common terminal and the earth ground to avoid instrument damage
or electric shock.
This multimeter displays DC voltage values as well as their polarity. Negative DC voltages
will display a negative sign on the left of the display.
(1)
Rotate the rotary switch to
or
(
is only for specific models). Default is
DC measurement mode,
will be displayed. Press
to switch into AC
measurement mode,
will be displayed.
(2)
Connect the black test lead to the
terminal and the red test lead to the
terminal.
(3)
Probe the test points and read the display. Press
to enable and cycle through
the manual ranges.
Note: When measuring AC voltage, press
to cycle through frequency measuring,
duty cycle measuring, and original measuring.
Measuring Resistance
Caution:
To avoid possible damage to your multimeter or to the equipment under
test, disconnect the circuit power and discharge all high-voltage
capacitors before measuring resistance.
(1)
Rotate the rotary switch to
.
(2)
Connect the black test lead to the
terminal and the red test lead to the
terminal.
(3)
Probe the test points and read the display. Press
to enable and cycle through
the manual ranges.
Summary of Contents for MP730026
Page 1: ...i Digital Multimeter Model MP730026...
Page 21: ...User Manual 18 3 Select I accept the agreement and then click Next...
Page 22: ...User Manual 19 4 Select the destination folder and then click Next 5 Click Install...
Page 31: ...User Manual 28 7 Click Open Directory to open the directory where the CSV files are saved...
