12 - Product Safety Information
WARNING:
•
This product should only be connected to an external power supply rated at 12V dc, with a minimum current rating of 2.5Amp.
Any external power supply used with this display should comply with relevant regulations and standards applicable in the country
of intended use.
•
This product should be operated in a well ventilated environment and, if used inside a case, the case should allow enough airflow
to ensure proper cooling of the product.
•
This product should be placed on a stable, flat, non-conductive surface in use and should not be connected by conductive items.
•
The connection of incompatible devices to the product connector interfaces may affect compliance and / or result in damage to
the unit and invalidate the product warranty.
•
All peripherals used in conjunction with this display device should comply with the relevant standards for the county of use and be
marked accordingly to ensure that safety and performance requirements are met. These articles include but are not limited to
keyboards, mice, Raspberry Pi devices or any other cables that may be connected but not supplied or recommended in the kit of
parts.
•
Where peripherals are connected that do not include the cable or connector supplied in the kit or recommended, the cable or
connector used must offer adequate insulation, protection and operation in order that the requirements of the relevant
performance and safety requirements are met for the intended country of use.
TO AVOID MALFUNCTION OR DAMAGE TO YOUR TOUCH SCREEN DISPLAY PLEASE OBSERVE THE FOLLOWING:
•
This device is static sensitive. Avoid handling the printed circuit boards whilst the product is powered. Only handle printed circuit
boards by the edges to minimise the risk of electrostatic discharge damage. Use anti-static precautions where possible.
•
Do not expose to water, moisture or place on a conductive surface whilst in operation.
•
Do note expose to direct heat from any source. This touch display solution is designed for reliable operation at normal ambient
room temperatures and those specified in our full product specification of -20°C to +70°C operation and -30°C to +80°C storage.
•
Do not connect power supplies other than those at the specified rating or damage may occur to the display and the printed circuit
boards.
•
Handle with care the touch screen interface connector as excessive force may damage the flexible connections.
Raspberry Pi is a trade mark of the Raspberry Pi Foundation
For further information relating to this product guide or assistance with installation of the
Raspberry Pi to our touch screen assembly, please contact:
Farnell Electronic Components
Canal Rd, Armley, Leeds LS12 2QQ
Email:
sales@
farnell.com
Telephone: +44
344 711 1111
10.1
″
IPS HD Resolution Touchscreen
Display for Raspberry Pi
P11
