#7
–
HDMI~HDMI
PCB
–
Pi3
#8
–
M2.5 Screws
#6
–
I2C Cable
#9
–
M2.5 Screws
Pre-assembled
4
–
Cable Accessory Pack Contents
Note: The cable accessory pack supplied should contain the above listed parts. If any item is missing, please
contact your local supplier for support.
5
–
Tools required for assembly
This product can be assembled using a Phillips screwdriver (1x100)
6
–
Environment and Handling
A clean working environment should be chosen to assemble the kit of parts.
CAUTION:
This item is static sensitive, please take precautions to ensure no damage can occur through
transmission of any static charge to the circuit board on the rear of the display and associated electronics.
7
–
Assembly method
The kit comes part assembled with item #9 (Standoffs), already attached to the rear of the TFT Display interface PCB
For a Raspberry Pi3 assembly you will require item #7 (HDMI~HDMI PCB). In this case item #3 is not used.
For a Raspberry Pi4 assembly you will require item #3 (HDMI ~Micro HDMI cable). In this case item #7 is not used.
An additional cable item #6 (I2C Cable) has been provided to allow I2C connection of the touch interface via the GPIO
connectors on the Raspberry Pi. This allows all ports of the Raspberry Pi to be utilised for other peripherals.
Note: Should you require an I2C connection method for the touch panel interface, please contact your local supplier for
information on how to connect and install the relevant drivers for this function
.
#3
–
HDMI~M-
HDMI cable-Pi4
#4
–
USBA~Micro
USB Touch Cable
#5
–
Internal
Power Link Cable
10.1
″
IPS HD Resolution Touchscreen
Display for Raspberry Pi
P4
