8. 469PC PROGRAM
CREATING A NEW SETPOINT FILE
8-5
8.4 CREATING A NEW SETPOINT FILE
1. To create a new Setpoint file, run the 469PC Program. It is not necessary to have a SR469 connected to the computer. The 469PC
status bar will indicate that the program is in “Polling Relay” mode and “Not Communicating”
2. Select Setpoints from the menu and choose the appropriate section of setpoints to
program, e.g. System Setup and enter the new setpoints. When you are finished
programming a page, select OK and store the information to the computer’s scratchpad
memory (note: this action does store the information as a file on a disk)
3. Repeat step 2. until all the desired setpoints are programmed.
5. Select File, Save As to store this file to disk. Enter the location and file name of the
setpoint file with a file extension of ‘.469’ and select OK.
•
The file is now saved to disk. See section 8.6 for downloading this setpoint file to the
SR469 relay.
Figure 8-5 CREATING A NEW SETPOINT FILE
Summary of Contents for SR469
