EDITING A SETPOINT FILE
8. 469PC PROGRAM
8-6
8.5 EDITING A SETPOINT FILE
1. To edit an existing Setpoint file, run the 469 PC program and establish communications with the connected relay via the front panel
RS232 port. The 469PC status bar should indicate “Communicating”
2. Select Communication, Computer from the menu, and select Off and OK to turn off
computer communications with the relay and place the PC program in “Editing File” mode.
3. Select Setpoints from the menu and choose the appropriate section of setpoints to
program, e.g. SR469 Setup and enter any new setpoints. When you are finished
programming a page, select OK and store the information to the computer’s scratchpad
memory (note this action does store the information as a file on a disk).
4. Repeat step 3. until all the desired setpoints are programmed.
5. Select File, Save As to store this file to disk. Enter the location and file name of the
setpoint file with a file extension of ‘.469’
•
The file is now saved to disk, see section 8.6 for downloading this setpoint file to the
SR469 relay.
Figure 8-6 Editing A Setpoint File
Summary of Contents for SR469
