MD-1000I / MD-2000I / MD-3000I
UPS Installation and Hook-Up
6.
UPS Installation and Hook-Up
All instructions in technical information pertaining to the operating environment
and operating conditions are mandatory and necessary to the proper function
and operation of the UPS.
For the installation of the UPS in a tower or rack configuration, the following in-
structions apply:
–
Avoid extreme temperatures and relative humidity.
–
Follow the instructions provided for the horizontal rack installation.
–
Make sure the unit has adequate ventilation with sufficient unhindered air-
flow.
–
Be careful when integrating the UPS in other systems, e.g. machines or
switch gear cabinets. Make sure the UPS' environment remains within the
specified temperature requirements. If heat is prone to accumulate in the
environment, you must act to provide suitable ventilation.
–
Only a base plate is suitable to anchor the unit.
6.1 UPS
Connection
These models come equipped with plug-and-socket connectors.
The UPS system contains components with high voltage and amperage.
Improper use or handling can lead to electrical shock, injuries with death
and/or property damage.
The protective earth conductor must be connected! If it is not grounded,
the connected equipment is also not earthed.
If operating with a generator, make sure not to reverse the connection's
polarity.
If the UPS is in an emergency stop (NOT-HALT) cycle, the UPS output will still
carry power. The connected equipment receives electricity for the duration
while the UPS' electricity backup function is operating.
MD Series
60
Summary of Contents for MD-1000I
