7 of 9
Part Number 020006402 12/2014
Air Compressor Kits
CONNECTNG THE AR PUMP TO THE STAND OUTLET
BOX
n
Wtoaiag
Before proceeding with this installation, make sure the
power to this box is disconnected.
1. Locate the outlet box under the stand. Open the cover
of the outlet box.
2. Remove one of the 1/2" dia. knock-outs on the side or
bottom of the box.
3. Route the loose end of pump cord and terminals
through the Romex connector, the box wall opening,
and then the Romex connector lock-nut. Tighten the
connector and lock-nut securely against the box wall.
4. Connect the brown wire to the open terminal available
on the switch labeled “Air compressor” as shown on the
wiring diagram below. Connect the blue wire to the
other two blue wires inside the box that are already
connected with wire-nut terminal.
5. “Ground” the pump to the unit using the ground screw
available on box and the green wire.
6. Replace the box cover and tighten the holding screws
securely.
CONNECTNG THE AR PUMP TO THE WALL OUTLET
An appropriate 3-wire power receptacle must be available
within 6 feet from the intended operating location of the air
pump kit. A locally furnished plug must be attached to the
power cord in order to be accepted by the local electrical
receptacle.
1. Locate a 3-wire plug. This plug (not furnished with kit)
must have a ground-wire connecting terminal.
2. Locate the loose end of the power cord attached to the
kit. All three wires are stripped to 1/2" length from the
end.
3. Connect all three wires to plug using the 1/2" stripped
ends or any other terminal requirements. Different
plugs and terminals may require different stripped
lengths.
4. Check cord and plug connection for any loose or bare
wires.
Electrical Conduit
11.5" (29.2 cm) Line
Dump Valve
220V to Air
Compressor
220V to Water
Booster
220V
220V
Air Pump
Wiring Diagram
for Junction Box
n
Wtoaiag
To avoid the risk of electrical shock, the installer must
check the following:
This pump kit must be grounded. In the event of an
electrical short circuit, grounding reduces the risk of
electrical shock by providing an escape wire for the
electrical current. This product is equipped with a
grounding-type cord. To reduce the risk of electrical
shock, be certain that the plug and cord are securely
assembled and that they are used only with a properly
grounded receptacle. Check with a qualified electrician
or serviceman if the grounding instructions are not
completely understood.
Do not use an extension cord or an adapter plug with
this equipment. Do not splice the furnished power cord
to a locally supplied cord. If another power cord must
be used, completely replace the existing cord with the
new one. Proceed with the electric connection of the
stand outlet box to the refrigeration unit electrical box
using the stand installation instructions packed with the
stand.
