9 of 9
Part Number 020006402 12/2014
Air Compressor Kits
Arrtchiag Aio PuIm rp Mpuariag Botcker — P.N. 00202676
OPENNG THE CARTONS
Contents of Mounting Bracket carton:
• Mounting bracket
• Bag containing four (4) bolts, four (4) nuts, four (4)
washers, four (4) 5-1/6 masonry lead anchors
Contents of the Multiplex Air Pump carton:
• Air pump
• Four (4) rubber mounting pads, four (4) bolts, and four
(4) washers
NSTALLNG THE MOUNTNG BRACKET
1. Determine the most convenient location. Keep in mind
the air pump will require periodic service.
2. To mount to a wall, four (4) lead anchors are provided
to attach the bracket to a masonry wall. Any other
means of attachment will have to be secured locally.
HOW TO ATTACH THE AR PUMP TO THE MOUNTNG
BRACKET
1. Four (4) rubber mounting pads, bolts, and washers are
provided for this purpose.
2. Insert the rubber pads into the holes in the bracket that
match the holes in the air pump.
3. Position the air pump on the pads and screw in the
bolts with washers. Tighten the bolts only enough to
expand the rubber pads. This will secure the pump.
Make sure you have taken into consideration servicing
the air pump, the air tank, and the air filter.
4. Connect the air line from the control panel or manifold
to 1/4" male flare fitting on the tank.
5. Make sure all connections are tight and that the air to
the CO
2
Gas Change-over Valve is turned to “CO
2
Gas.”
6. Plug the pump service cord into a 120V outlet. The
pump should run and cycle “off” when the pressure
gauge reaches 90 psi (6.2 bar). The pump should cycle
“on” when the pressure drops to 70 psi (4.8 bar). If
adjustments are necessary, remove the cover of the
pressure control and follow instructions.
Poessuoe
Cparopl Swirch
Aio Liae
Rubbeo Ptds
Cpadeastre
Dotia Hpse
110 Vplr
Elecroictl Ourler
