PAGE 20 — DAC7000 SERIES GENERATORS• OPERATION AND PARTS MANUAL — REV. #0 (02/15/16)
Figure 4. Generator Components
17.
Fuel drain Plug
— Remove this plug to drain fuel
from the fuel tank.
18.
Frame Ground Lug
— Connect a ground strap
between this lug and a ground rod. Make sure that the
ground rod is inserted deep into the ground to provide
a good earth ground. Consult with local Electrical and
Safety Codes for proper connection.
19.
Receptacle
— Provides 120/240 volts output at 50
amps.
20.
Receptacle
— Provides 120/240 volts output at 30
amps.
21.
Receptacle
— Provides 120 volts output at 30 amps.
22.
Receptacle G.F.C.I.
— This receptacle provides 120
volts output at 15 amps.
23.
GFCI Circuit Breaker
— This single pole circuit
breaker provides circuit protection (250V @15 amps)
for the G.F.C.I receptacle.
24.
Main Circuit Breaker
— This 2-pole circuit breaker
provides circuit protection (265V @25 amps) for the
Electric Parts Assembly.
25.
AC Voltmeter
— This voltmeter indicates (with a
mark) the rated 60 Hz (single-phase) output voltage.
In addition the voltmeter can also be used as a
diagnostic tool. If the voltmeter indicator (needle) is
below the rated voltage, engine problems may exist
(low/high RPM's). To prevent damage to the generator
or power tools turn the generator OFF and consult your
authorized Multiquip service dealer.
26.
Hour Meter
— Indicates number of hours machine
has been in use or hours engine was run.
27.
Idle Control Switch
— The generator is provided with
an automatic idle control device for noise suppression
and reduced fuel consumption.
The automatic idle control automatically engages under
a no-load condition. With the automatic idle control
switched “
ON
”, the engine revolutions will automatically
drop to about 2200 rpm (low-speed operation) within
3 seconds after the load stops. When the operation is
resumed, the engine speed is automatically increased
to about 3600 rpm (high-speed operation) as soon as
the load is connected.
28.
Warning Lamp Display
— Lights red when the
following conditions occur:
Oil Pressure Lamp
— If the oil pressure drops
suddenly, the oil pressure lamp will go on, and
the generator will shut down.
Charge Lamp
— The charge lamp will go
on when the battery fails to charge, and the
generator will shut down.
Water Temperature Lamp
— The water
temperature lamp will go on if the temperature
rises to an abnormally high level, and the
generator will shut down.
29.
Starter Switch
— With key inserted turn clockwise to
start engine.
30.
Oil Filter
— Provides oil filtering for the engine
NOTICE
This
KUBOTA
engine is equipped with a low oil
shutdown capability. A built in sensor will automatically
turn off the engine should the oil level fall below a safe
operating condition. Make sure the generator is placed
on level ground. Placing the generator on level ground
will ensure that the low oil sensor will function properly.
COMPONENTS (GENERATOR)
Summary of Contents for DAC7000SS
