MVH306D/DS PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #11 (02/04/14) — PAGE 19
6.
After starting the engine, continue to warm up the engine
for about 3 to 10 seconds especially in cold weather.
7.
If the buzzer does not stop sounding after the engine has
started, shutdown engine immediately and check engine
oil level. The buzzer functions as a engine oil level alam
warning device.
Figure 17. Starter Switch (Option)
Recoil Start
1.
Open the fuel cock (Figure 15).
2.
Move the throttle lever to the
START
position (Figure 16).
3.
Grasp the starter grip (Figure 18) and slowly pull it out. The
resistance becomes the hardest at a certain position,
corresponding to the compression point. Pull the starter
grip briskly and smoothly for starting.
Figure 18. Engine Start Handle
4.
Push down decompression lever (Figure 19) and
release.
TRAVELING
Figure 19. Decompression Lever
5.
If the engine does not start, repeat steps 4 and 5.
Figure 20. Throttle Lever (Fast)
1. Grasp the compactor's hand grip (Figure 20), and move the
engine throttle lever (Figure 20) quickly to the
fast
position.
2. With the throttle lever in the fast position, the engine speed
should be around 3,600 RPM, therefore engaging the cen-
trifugal clutch
5.
If the engine fails to start,
DO NOT
continue to rotate the
ignition key for more than 5 seconds. Return the key to the
RUN
position and wait 10 seconds before starting again
OPERATION
While the engine is running, never try to turn the ignition key
to the
START
position.
CAUTION
Make sure to follow all safety rules referenced in the safety
section of this manual before operating compactor. Keep
work area clear of debris and other objects that could cause
damage to the compactor or bodily harm.
CAUTION
When starting a unit with an electric strart capability, a
decompressor is not normally required. However, when ambient
temperature or battery charger level is low, use of a decompressor
will help make the start-up easier.
NOTICE
