MVH406GH PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #3 (02/04/14) — PAGE 19
5.
Place the
engine ON/OFF
switch (Figure 19) in the “
ON
”
position.
6.
Grasp the starter grip (Figure 20) and slowly pull it out. The
resistance becomes the hardest at a certain position,
corresponding to the compression point. Pull the starter
briskly and smoothly for starting.
3.
Place the
choke lever
( Figure 17) in the “
OPEN”
position
if starting a cold engine.
4.
Place the
choke lever
( Figure 18) in the “
CLOSED”
position if starting a warm engine or if the temperature is
warm.
Figure 20. Engine Start Handle
TRAVELING
7.
If the engine has started, slowly return the choke lever
(Figure 18) to the “
CLOSED”
position. If the engine does
not start, repeat steps 1 through 6.
8.
Before the compactor is placed into operation, run the
engine for several minutes. Check for fuel leaks and noises
that would be associated with a loose component.
Make sure to follow all safety rules referenced in the safety section
of this manual before operating compactor. Keep work area
clear of debris and other objects that could cause damage to the
compactor or bodily harm.
Figure 21. Throttle Lever (Fast)
1. Grasp the compactor's hand grip (Figure 21), and move the
engine throttle lever (Figure 21) quickly to the
fast
position.
2. With the throttle lever in the fast position, the engine speed
should be around 3,600 RPM, therefore engaging the cen-
trifugal clutch
CAUTION
MVH-406GH — OPERATION
Figure 17. Engine Choke Lever (Open)
Figure 18. Engine Choke Lever (Closed)
Figure 19. Engine ON/OFF Switch (ON position)
