PAGE 50 — SG1400/1600C4F STUDIO GENERATOR • OPERATION MANUAL — REV. #0 (07/22/20)
RADIATOR CLEANING
The radiator (Figure 56) should be sprayed (cleaned) with
a high pressure washer when excessive amounts of dirt
and debris have accumulated on the cooling fins or tube.
When using a high pressure washer, stand at least 5 feet
(1.5 meters) away from the radiator to prevent damage to
the fins and tube.
Figure 56. Radiator Cleaning
COOLANT (ANTIFREEZE/SUMMER COOLANT/
WATER)
Cummins recommends antifreeze/summer coolant for use in
their engines, which can be purchased in concentrate (and
mixed with 50% demineralized water) or pre-diluted. See the
Cummins Operation and Maintenance Manual
for further
details.
WARNING
If adding coolant/antifreeze mix to the
radiator,
DO NOT
remove the radiator
cap until the unit has completely cooled.
The possibility of
hot!
coolant exists
which can cause severe burns.
DEF TANK SUPPLY MODULE FILTER
Replace DEF Supply Module Filter every 4500 hours.
1. Remove cap (Figure 57) at the bottom of DEF supply
module to gain access to the paper filter.
Figure 57. DEF Supply Module Filter
2. Discard the old filter.
3. Install the new filter onto the holder.
4. Insert filter and holder back into DEF supply module.
5. Reinstall cap.
GENERATOR STORAGE
For long term storage of the generator the following is
recommended:
1. Drain the fuel tank completely. Treat with a fuel stabilizer
if necessary.
2. Completely drain the oil from the crankcase and refill,
if necessary, with fresh oil.
3. Clean the entire generator, inside and outside.
4. Disconnect the battery.
5. Make sure engine coolant is at proper level.
6. Cover the generator and store in a clean, and dry place.
DEF TANK
PUMP MODULE
FILTER
CAP
HOLDER
MAINTENANCE