PAGE 36 — DCA-100SSVU— OPERATION AND PARTS MANUAL — REV. #0 (11/05/07)
4. Verify that the
Engine Running
status LED on the MPEC unit
(Figure 44) is
ON
(lit) after the
engine has been started.
Figure 44. Engine Running LED (ON)
Manual Start-up
Procedure
Figure 42. MPEC Control Switch
(Manual Position)
DCA-100SSVU — GENERATOR START-UP PROCEDURE (MANUAL)
The engine's exhaust contains harmful emissions.
ALWAYS have adequate ventilation when operating
.
Direct exhaust away from nearby personnel.
Before Starting
Figure 39. Engine Enclosure Doors
1. Place the
main, G.F.C.I.,
and
aux.
circuit breakers
(Figure 38) in the
OFF
position prior to starting the engine.
Figure 38. Main, Aux. and GFCI
Circuit Breakers (OFF)
2. Make sure the the
voltage change-over board
has
been configured for the desired output voltage.
3. Connect the load to the
receptacles
or
the
output
terminal lugs
as shown in Figure 13. These load
connection points can be found on the output terminal
panel and the output terminal panel’s hard wire hookup
panel.
4. The output terminal lugs are protected by a plastic cover.
Remove this cover to gain access to the terminals.
Tighten terminal nuts securely to prevent load wires from
slipping out.
5. Close all engine enclosure doors (Figure 39).
CAUTION - LETHAL EXHAUST HAZARD
3. Once the engine starts, let it engine run for 1-2 minutes.
Listen for any abnormal noises. If any abnormalities
exists shutdown the engine and correct the problem.
If the engine is running smoothly, place the engine
speed switch (Figure 43) in the
“
HIGH”
(up) position.
2. Once the engine glow plugs have been warmed, place
the
MPEC Control Switch
in the
MANUAL
position to
start the engine (Figure 42).
Figure 41. Engine Speed Switch (Low)
Figure 43. Engine Speed Switch (High)
NEVER!
manually start the engine with the
main
,
GFCI
or
auxiliary
circuit breakers in the
ON
(closed) position.
WARNING - STARTING THE GENERATOR
1. Place the engine speed switch (Figure 41) in the “
LOW
”
(down) position.
