PAGE 28 — DCA-150SSJU3— OPERATION AND PARTS MANUAL — REV. #0 (11/14/07)
3.
Once the “Adjust Backlight” menu item has been
highlighted touch the “Enter Button” to activate the
“Adjust Backlight” function.
4.
Use the “Arrow Buttons” to select the desired backlight
intensity.
5.
Touch the “Menu Button” to return to the main menu.
6.
Touch the “Menu Button” to exit the Main menu and
return to the engine parameter display.
Contrast Adjustment
1.
Starting at the single or four engine parameter display,
touch the “Menu Button”.
2.
The main menu will pop up on the display. Use the “Arrow
Buttons” to scroll through the menu until “Adjust Contrast”
is highlighted.
3.
Once the “Adjust Contrast” menu item has been
highlighted touch the “Enter Button” to activate the
“Adjust Contrast” function.
4.
Use the “Arrow Buttons” to select the desired contrast
intensity.
5.
Touching the “Menu Button” will take you back through
the menus.
GO TO 1-UP DISPLAY
STORED CODES
G
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
ADJUST BACKLIGHT
ADJUST BACKLIGHT
ADJUST BACKLIGHT
GO TO 1-UP DISPLAY
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
STORED CODES
G
ADJUST BACKLIGHT
98%
14.2
57 PSI
1000 RPM
LOAD RPM
BATT VOLT
ENG RPM
OIL PRES
98%
14.2
57 PSI
1000 RPM
LOAD RPM
BATT VOLT
ENG RPM
OIL PRES
COOL
1800 RPM
0
1500
3000
TEMP
ENG RPM
GO TO 1-UP DISPLAY
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
STORED CODES
G
ADJUST BACKLIGHT
ENGINE CONF
SETUP 1-UP DISPLAY
SETUP-4-UP DISPLAY
SELECT UNITS
STORED CODES
G
ADJUST BACKLIGHT
ADJUST CONTRAST
ADJUST CONTRAST
DCA-150SSJU3 — DIAGNOSTIC DISPLAY
