PAGE 43 — DCA-25SSI2 — PARTS AND OPERATION MANUAL—FINAL COPY (06/29/01)
WARNING:
Before Starting
Engine
1. Check the lubricating oil level prior to starting the engine.
Make sure the generator is level. The oil level must be
maintained between two notches on the dipstick.
2. When there is not enough lubricating oil, fill the crankcase
with high grade motor oil. Use a high quality detergent
oil classified CC or higher (See Table 8 on page 33).
3. Check the coolant level in the radiator and subtank.
Replenish with antifreeze as necessary. Always maintain
the coolant level between the
FULL
and
LOW
markings
on the coolant container. Be sure that the radiator cap is
fastened securely.
4. Check the fuel level on the fuel gauge. If fuel is low, fill
the fuel tank with clean fresh unleaded automotive diesel.
If diesel spillage occurs, completely wipe up the spilled
fuel immediately.
Before Starting
Generator and Control Panel
CAUTION:
1. Be sure to disconnect the electrical load and switch the
main, load
main, load
main, load
main, load
main, load and G.F
G.F
G.F
G.F
G.F.C
.C
.C
.C
.C.I.
.I.
.I.
.I.
.I. circuit breakers (Figure 34) to
the “OFF” position prior to starting the engine.
NEVER
start the engine with the
main,
main,
main,
main,
main, GFCI
GFCI
GFCI
GFCI
GFCI or load
load
load
load
load circuit breakers
in the
ON
position.
The engine's exhaust contains harmful
emissions. A L
A L
A L
A L
A LW
W
W
W
WA
A
A
A
AY S
Y S
Y S
Y S
Y S ventilate the
exhaust when operating inside tunnels,
excavations or buildings. Direct exhaust
away from nearby personnel.
Figure 34. Main, GFCI and
Load Circuit Breakers
DCA-25SSI2 — GENERATOR START-UP PROCEDURE
2. Connect the load to the UNV terminals as shown in
Figure 35. These terminals can be found on the output
terminal panel, (see page 29 Figure10). To gain access
to the output terminals lift the UNV cover. Tighten
terminal nuts securely to prevent load wires from slipping
out.
Figure 35. UNV Terminal Lugs (Load)
NEGA
TIVE
POSTIVE
BATTER
Y
3. Connect the negative battery cable (BLACK) to the
negative post on the battery (Figure 36).
Figure 36. Battery Connections
Summary of Contents for POWER WHISPERWATT DCA-25SSI2
