PAGE 22 — PRO SERIES WALK-BEHIND TROWELS • OPERATION MANUAL — REV. #0 (9/21/17)
SET-UP
Blade Pitch Cable Installation
1. Turn the star wheel
counterclockwise to pitch the
blades flat.This releases tension on the pitch cable
(Figure 7).
Figure 7. Blade Pitch Cable Adjustment
2. Remove brass set nut #1 from the end of the blade
pitch cable (Figure 8).
Figure 8. Blade Pitch Cable
3. Thread brass set nut #2 as far as possible towards the
blade pitch cable (Figure 8).
4. Insert the blade pitch cable end through the yoke eyelet
(Figure 9). Tighten brass set nut #1 by hand to remove
all the slack from the cable.
BLADE PITCH
STAR WHEEL
INCREASE
BLADE PITCH
(CW)
DECREASE
BLADE PITCH
(CCW)
BLADE
PITCH
CABLE
BRASS SET
NUT #1
BRASS SET
NUT #2
Figure 9. Cable Yoke Attachment
5. Tighten brass set nut #2 against the yoke boss to
secure the cable in place.
6. Tighten brass set nut #1 against the yoke boss.
Throttle Cable Installation
1. Uncoil the throttle cable and housing.
2. Make sure the throttle cable is fed through the tube on
the underside of the handle and secured to the upper
handle and main tube with zip ties.
3. Place the throttle lever (Figure 10) in the
RUN position.
Figure 10. Adjusting Cable Tension
BLADE
PITCH
CABLE
YOKE
YOKE
EYELET
BRASS SET
NUT #2
BRASS SET
NUT #1
IDLE
RUN
THROTTLE
LEVER
LOCKING
NUT
THROTTLE CABLE
RECEIVER
CABLE
RETAINING
SCREW
THROTTLE
CABLE
THROTTLE
WIRE
