PAGE 22 — PRO46 SERIES WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #1 (8/20/15)
ASSEMBLY AND INSTALLATION
INSTACLUTCH CABLE INSTALLATION
1. Uncoil the free end of the clutch cable.
2. Check that the clutch cable (Figure 13) is attached to
the handlebar cable anchor.
Figure 13. Handlebar Clutch Cable Anchor
3. Check that the clutch cable is fed along the tube and
secured with zip ties.
4. Using a 7/16” wrench remove the three 1/4" retaining
bolts (Figure 14) that secure the clutch cover to the
frame.
Figure 14. Clutch Cover Removal
CABLE
ANCHOR
HANDLEBAR
CLUTCH
CABLE
BOLT
CLUTCH COVER
5. Route the clutch cable (Figure 15) underneath the top
most rung of the guard ring.
Figure 15. Clutch Cable Routing
6. Remove the 5/16” outer nut (Figure 16) and rubber cap
from the threaded end on the clutch cable.
Figure 16. Outer Nut And Rubber Cap Removal
CLUTCH
CABLE
TOP RUNG
OF
GUARD
RING
5/16”
OUTER
NUT
THREADED END
CLUTCH CABLE
RUBBER
CAP
