PRO46 SERIES WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #1 (8/20/15) — PAGE 23
ASSEMBLY AND INSTALLATION
7. Adjust the 5/16" inner nut (Figure 17) for a 7/8" distance
from the threaded end on the clutch cable to the inner
nut.
Figure 17. Inner Nut Adjustment
8. Insert the exposed cable (Figure 18) into the cable slot
on the cable anchor.
Figure 18. Inserting Clutch Cable
Into Cable Anchor
5/16”
INNER
NUT
CLUTCH CABLE
NOTICE
Positioning the inner nut 7/8" from the clutch cable's
threaded end will help ensure proper clutch gap
adjustment.
CABLE ANCHOR
THREADED END
CLUTCH CABLE
EXPOSED
CABLE
CABLE
ANCHOR
CABLE
SLOT
9. Place outer nut (Figure 19) onto the threaded end of the
clutch cable. Hand tighten nut against the cable anchor.
Figure 19. Attaching Clutch Cable
To Cable Anchor
10. Using two 1/2" wrenches tighten the inner and outer
nut against the cable anchor.
11. Connect the clutch cable to the clutch anchor by placing
the spring loop over the clutch anchor flats as shown
in Figure 20. Use needle nose pliers to slide the spring
loop fully into the groove.
Figure 20. Spring Loop Attachment
.
EXPOSED
CABLE
CABLE
HOUSING
OUTER NUT
INNER NUT
CABLE
ANCHOR
CLUTCH
CABLE
SPRING
SPRING
LOOP
CLUTCH
ANCHOR
CLUTCH
ANCHOR
FLAT
