PAGE 26 — PRO46 SERIES WALK-BEHIND TROWEL • OPERATION AND PARTS MANUAL — REV. #1 (8/20/15)
ASSEMBLY AND INSTALLATION
INSTALLATION OF WEIGHTS (BLADE)
1. Open the locking pin (Figure 26).
2. Place the weight(s) onto the weight posts and insert
the locking pin into the weight post hole nearest the
weight(s).
3. Close the locking pin.
4. A properly installed weight is shown in Figure 26 letter
(
A
).
Figure 26. Weight Installation
NOTICE
The four weights are an
optional
feature. The use
of the weights is determined by the operator. It is
recommended that the weights be equal on both sides
of the weight posts.
A
LOCKING PIN
WEIGHT
POST
WEIGHT
POST
HOLE
INSTALLATION OF BRUSH WEIGHT KIT
1. Slide the 1/4-20 X 1-1/4" screw into the brush channel
as shown in Figure 27.
2. Once correctly positioned, place the brush weights (3)
onto the 1/4-20 X 1-1/4" screw as shown in Figure 27.
3. Insert 1/4" flat washer and 1/4"-20 nyloc nut onto the
screw.
4. Using a 7/16" wrench, tighten the 1/4-20 nyloc nut.
5. Repeat for opposite side.
Figure 27. Brush Weight Kit Installation
NOTICE
The six brush weights are an
optional
feature. The
use of the weights is determined by the operator. It is
recommended that the weights be equal on both sides
of the brush.
NOTES:
1 FRESNO BRUSH WEIGHT
KIT INSTALLATION IS
IDENTICAL FOR BOTH SIDES.
1
1
1/4-20
NYLOC
NUT
CHANNEL
1/4-20 X 1-1/4"
SCREW
FRESNO
BRUSH
WEIGHTS
