PAGE 22 —R2000 RIDE-ON STATIC ROLLER — OPERATION & PARTS MANUAL — REV. #2 (03/20/06)
Battery Check
A 12-volt DC battery (Figure 9) is shipped dry, and will require a
proper electrolyte level for operation.
ALWAYS
be sure that the battery cables are properly
connected to the battery terminals as shown below. Generally
the
RED
cable will be connected to the positive terminal of
the battery, and the
BLACK
cable will be connected to the
negative terminal of the battery.
If the battery cables are connected
incorrectly, electrical damage will occur
causing damage to the roller's electrical
circuits. Pay close attention to the polarity
of the battery when connecting the battery.
WARNING
Figure 9. Battery
R2000 — INSPECTION
Water System Check
1.
Check the water tank, located under the operator's seat, to
see if filled (Figure 8). Add water if necessary. The water
tank has a capacity of approximately 21 gallons (79.5 liters).
Figure 8. Water Tank Check
2.
Water can also be added to the front and rear rollers. To fill,
remove pipe plug from the roller side plate and position
roller so that the hole is at the top. The right side cover must
be removed to fill the rear roller. Replace plugs and side
cover after filling. Thirty gallons (250 lbs.) of water can be
added to the front rollers and 51 gallons (427 lbs.) of water
can be added to the rear roller.
3.
Protect water from freezing by adding antifreeze or draining
water tank when not in use. Use only clean water in water
tank.
