PAGE 26 — HTN 31V
HTN-SERIES • RIDE-ON POWER TROWEL — OPERATION MANUAL — REV. #0 (06/06/07) — PAGE 26
Figure 13. Air Cleaner Components
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
1.
Release the latches located on either side of the air cleaner
cover (Figure 13), and remove the cover.
2.
Remove the foam precleaner from the paper air cleaner
element.
3.
Wash the precleaner in warm water with detergent. Rinse
the precleaner thoroughly until all traces of detergent are
eliminated. Squeeze out excess water (do not wring). Allow
the precleaner to air dry.
4.
Saturate the precleaner with new engine oil. Squeeze out
all excess oil.
5.
Reinstall the precleaner over the paper air cleaner element.
6.
Reinstall the air cleaner cover and secure the latches.
Air Cleaner (Daily)
The Kohler 27 hp and 28 hp EFI engines are equipped with a
replaceable, high-density paper air cleaner element. Most are
also equipped with an oiled-foam precleaner which surrounds
the paper element.
Check the air cleaner daily or before starting the engine. Check
for and correct heavy buildup of dirt and debris along with loose
or damaged components.
NOTE
Operating the engine with loose or
damaged air cleaner components
could allow unfiltered air into the
engine causing premature wear and
failure.
Precleaner Service
If so equipped, wash and re-oil the precleaner every 25 hours of
operation (more often under extremely dusty or dirty conditions).
To service the precleaner perform the following steps, refer to
Figure 13:
HTN-SERIES — MAINTENANCE
