PAGE 20 — STXD6i RIDE-ON TROWEL• OPERATION MANUAL — REV. #2 (05/28/15)
BASIC ENGINE
1
3
4
5
6
8
10
12
13
14
15
11
9
2
7
16
16
19
20
21
17
18
Figure 6. Basic Engine
1.
Air Filter
— Helps provide clean source of air flow to
turbocharger and engine.
2.
Muffler
— Exhaust gases routed through here.
3.
Fan belt
— Driven by the engine crank during
operation, drives the water pump/fan as well as the
alternator.
4.
Cooling Fan
— Driven by the V-belt, the cooling fan
cools the engine by cooling water/antifreeze mixture
that circulates through the engine block and cylinder
head.
5.
Crankshaft V-Pulley
— Check fan V-belt between
V-Pulley and alternator to determine proper belt
tension.
6.
Water Pump
— Circulates coolant flow through engine.
7.
Oil Filler Port
— Remove to add fresh crankcase oil.
8.
Oil Drain Plug
— Remove plug to drain crankcase oil.
9.
Injection Pump
— Provides equal fuel flow to injectors.
10.
Oil Filter
— Spin-on type, filters oil for contaminants.
11.
Oil Pressure Switch
— Monitors oil level.
12.
Oil Dip Stick
— Remove to check amount and
condition of oil in crankcase.
13.
ECO Governor
— Controls engine rpm.
14.
Flywheel
— Main power is taken off from flywheel end.
15.
Fuel Filter
— Removes dirt and water from the fuel.
16.
Lifting Eye
— Two lifting eyes are provided if the
removal/installation of the engine becomes necessary.
17.
Air Intake Port
— Provides air from the air cleaner to
the turbocharger unit.
18.
Turbocharger
— Provides pressurized intake air to the
cylinder by means of a turbine energized by exhaust
gas that rotates the blower.
19.
Starter
— Starts engine when ignition key is rotated
to the "
START
" position.
20.
Alternator
— Provides current to the electrical
system and charges the battery. Driven by means of
a crankshaft/V-belt pulley system.
21.
Fan Belt Tension Adjustment
— This bolt provides
means to adjust the V-belt tension at the alternator
bracket.
