PAGE 24 — WT5C SERIES WATER TRAILER • OPERATION MANUAL — REV. #6 (05/28/21)
OPERATION
DISCHARGING WATER
The following procedure shows how to discharge water
from the water tank using the CAM and groove male QD
couplers.
1. Remove dust cap from the desired CAM and groove
male QD port from the upper manifold.
2. Place spray bar and manifold control handles in the
discharge position as referenced in Table 5.
3. Figure 20 represents a typical water discharge
application utilizing the rear spray bar.
NOTICE
Prior to engine start, the pump
MUST BE
primed. This
is accomplished by removing the Pump Fill Cap and
filling the Pump Casing with water and then re-securing
the fill cap.
Figure 20. Discharging Water
SPRAY
SPRAY
2.0” CAM AND
GROOVE MALE QD
2.0” CAM AND
GROOVE MALE QD
FRONT
REAR
