MultiScree
∂
Channel
Setting the Time and Date
It is very important to have the current time and date set correctly on the
Production Unit. It is used for scheduling, and also for clocks displayed as part of
a sequence. To set the time and date, first open the Configuration Editor as
described on
page 85
. Then, click the button labelled
Set Current Time &
Date
. Follow the steps below to set the correct time and date.
[a]
Click on the hours, minutes or seconds value that you wish to change. There
are several ways to change the number. You can type a new number on the
keypad. You can also increase or decrease the number by 1 by pressing the
cursor up
or
down
keys, or by clicking the up and down arrow icons at the
right side of the entry box.
[b]
Continue changing numbers until the time is correct. Also ensure that the
AM or PM setting is appropriately set.
[c]
Click the drop-down button next to the date to bring up the Calender. The
month and year are shown at the top of the calendar. You can click the
small grey buttons to the left and right of the month and year to cycle
forward or backward one month.
[d]
To select a specific month, click the current month and select the month
you want from the drop-down list.
[e]
To select a specific year, click the current year. Two buttons will appear to
the left of the date. Click the top button to increase the year by one, and the
bottom button to decrease the year by one.
88
