Page - 3
www.multispanindia.com
PC-1044
Working
1). When pulse comes from sensor, upper display indicates increment in COUNT in
Instrument. Lower Display indicates Set Count Value .
2). For Manual Mode, set time = 00.0 sec. and for Auto Reset Mode, set time = 00.1 to
99.9 sec.
3). When process value = Set value, Relay energies. Relay remains ON for Auto Reset
Time Relay turns off after completion of time. If time is set at 00.0 sec. then relay
remains ON until RST key is pressed.
4). If there is a power failure the last reading is stored in the memory and Counter starts
resume counting from the last stored value, when power ON.
5). To restart Counting or to Reset press RST key. Upper display will show 0000 and
the counting will restart.
6). The proximity switch give pulse to counter every time the metal on the roller is sensed.
Press
key
Press
key to save & exit
SET
SET
ENT
ENT
Change by
key.
To shows over count Yes/ No
Change by
key.
Speed Of count
SLOW: MAX RPM 500
MEDIUM: MAX RPM 5000
FAST: MAX RPM 15000