CommPlete 4000 Communications Server Overview
29
2 Remove the top cover from the CommPlete 4000 by removing the seven cover mounting
screws located in the back of the CommPlete 4000. See figure 4-3.
3 Remove the two chassis mounting screws from the card cage. See figure 4-4.
4 Being careful to maintain slack in the power cables, lift the card cage up and over so
that it rests along side the chassis.
5 Remove the screw that secures the NIC board to the chassis at the back of the CommPlete
4000.
6 Remove the NIC board from the midplane.
7 To replace the NIC board, verify NIC configuration. Refer to the Installation
Instructions in the appropriate NIC section of this manual.
8 Install the new NIC board by following steps 1-4 in reverse order and sense. That is,
a. Attach NIC to its midplane socket.
b. Secure NIC to rear of chassis with screw.
c. Re-install card cage (2 screws). Make sure the power cables are securely
attached.
d. Replace top cover (7 screws).
e. (Two people are needed.) Replace CommPlete 4000 into its rack enclosure.
7 If other cards are being installed, perform those procedures below now, and then remount
the CommPlete 4000
in the enclosure.
Removing ISI Boards
Note
: If removing or replacing the single ISI board on the left side (looking from the front) of
the midplane, card cage removal is not necessary. Ignore steps 3 through 5.
1 Remove the CommPlete 4000
from rack enclosure (two people are needed). Follow the
procedure Disconnecting Cables and Removal from Enclosure presented above.
Summary: after powering down the unit and disconnecting all power and signal cables,
employ two persons to remove its rack-mounting screws and lift the unit out of the rack.
2 Remove the top cover from the CommPlete 4000 by removing the seven cover mounting
screws located in the back of the CommPlete 4000. See figure 4-3.
3 Remove the two chassis mounting screws from the card cage. See figure 4-4.
4 Being careful to maintain slack in the power cables, lift the card cage up and over so
that it rests along side the chassis.
5 Remove screws that secure the serial card to the chassis at the back of the
CommPlete 4000
.
6 Remove the serial card(s) from the midplane.
7 To replace the serial card(s), verify the configuration of the cards. See the installation
instructions in the serial card section(s) of this manual.
8 Install the new serial card(s) by following steps 1-6 in reverse. That is,
a. Attach serial card(s) to midplane socket(s).
b. Secure serial card to rear of chassis with screw.
c. Re-install card cage (2 screws). Make sure the power cables are securely
attached.
Summary of Contents for CommPlete 4000
