SPECIFICATIONS
14
Conduit
®
300 Series IoT Programmable Gateway MTCDT3AC-L4G1/-EN Hardware Guide
Front Panel Connectors
Label
Description
CELL1, CELL2
Cellular antenna inputs (varies with model).
CELL2 - Primary, CELL2 - Diversity
WiFi
Wi-Fi/Bluetooth antenna inputs (varies with model).
GPS
GPS antenna inputs, GNSS capable, supports 3.3 V-powered LNA antenna.
RS-232
RS-232/RS-422/RS-485 serial connector.
AP1, AP2
Slots for MultiTech accessory cards (varies with model). You can install an accessory card in
either slot. Both slots can be occupied at one time.
RF
For LoRa gateway accessory cards only (varies with model), LoRa antenna connector.
USB DEV
Standard USB 2.0 Device interface with Micro B connector. Initially setup as USB Gadget
Serial Interface but can be user-defined.
ETHERNET 1-4
Ethernet Ports-RJ-45 receptacle for 10/100/1000TX speed (Ethernet Switch).
Caution:
Ethernet ports and command ports are not designed to be connected to a public
telecommunication network or used outside the building or campus.
Caution:
Les ports Ethernet et de commande ne sontpas conçus pour être raccordés à
un réseau detélécommunications public.
USB HOST
High-speed, standard USB 2.0 Type A connector. 500mA maximum current draw. You can
plug into the Host port a device such as a flash drive, camera, or printer if the Linux kernel
has the appropriate driver.
POE
POE (Power over Ethernet) receptacle, IEEE 802.3at compatible, 37-57V (user-supplied
power source with 25 W minimum) with 10/100/1000TX speed
Power + -
Terminal block connector, 12VDC (Other power option: POE)
SIM
3FF SIM (Micro SIM) card slot
SD Card
SD card slot
Device ground (install ground screw on either front or back panel).